Feature:
1. LCD DISPLAY: Energy meter adopt 4 bit LCD display to accurately measure active power quantity, meter address, baud rate, constant, and effect level can be modified
2. ACCURATE AND EASY INSTALLATION: DIN rail meter adopts 1 phase 2 wire connection and 35mm guide rail installation, with accuracy up to 1 level
3. TECHNICAL PARAMETERS: Pulse constant is 400imp/1600imp, data storage time more than 20 years, with RS485 remote meter reading function
4. MULTI FUNCTION: Energy meter can be powered off, with backlit, switch output, can display total power, current, voltage, power, power factor, frequency, CTCS, can accurately measure active energy
5. LARGE SCREEN EYE PROTECTION: This is a power meter with a large screen LCD display to keep your eyes from getting tired
Specification:
Item Type: Energy Meter
Model Number: DDM75SC
Number of Phases: Single phases
Relative Humidity: ≤95%
Ambient Temperature: -35~65℃
Accuracy: Level 1
Current Specification: 10(40)A
Maximum Working Current: 100A
Measured Energy Range: 0.0-99999.0kwh
Indicate Current Specification: Reference current(maximum current)
Data Display: 7 Bit LCD display
Installation Mode: Rail installation
Functions And Features:
35mm standard DIN rail mount, conforming to DIN EN50022.
6 widths (modulus 12.5mm), in line with DIN43880 standard.
Standard configuration 5+1 (99999.1KWh) LCD display.
Two LEDs indicate the power status (green) and the power pulse (red).
Unidirectional measurement of single phase two wire active power consumption. This is independent of the direction of the load current. Comply with the standard IEC 62053-21.
Extend the terminal cover for safe use.
Package List:
1 x Energy Meter
1 x User Manual
Note:
1. During instrument installation, connect cables according to the wiring diagram in the user manual;
2. The instrument should be installed in a dry and stable place, can be installed indoors, avoid direct sunlight, humidity, heat, mold, smoke, dust, sand and corrosive gas
3. After the test seal can be installed and used, not sealed or storage time is too long, the instrument can be retested;
4. Only experienced electrician or professional technical personnel can install the meter, please read the manual;
5. Must be installed on the refractory wall, not easy to shake;
6. It is recommended to use copper wire input when wiring, to avoid bad contact caused by burning table;
7. When the meter is correct, the indicator lights up. The load capacity of the meter is between 0.05lb and lmax, excessive capacity will cause burnout.
